skindanax.blogg.se - Tp link ac1200

#Tp link ac1200 tv#

The required antenna impedance is 50 ohms. Antennas not included in this list or having a gain greater than 3 dBi are strictly prohibited for use with this device. This device has been designed to operate with the antennas listed below, and having a maximum gain of 5 dBi. Note: Please don’t use the product outdoors in France.

Within a radius of 20 km from the centre of Ny-Ålesund This subsection does not apply for the geographical area General authorization required for outdoor use and This device is intended for home and office use in all EU countries (and other countries following the EU directive 1999/5/EC) without any limitation except for the countries mentioned below: In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.” “To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. Such modifications could void the user’s authority to operate the equipment.

#Tp link ac1200 tv#

Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Operation is subject to the following two conditions:ġ This device may not cause harmful interference.Ģ This device must accept any interference received, including interference that may cause undesired operation.Īny changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules.

Consult the dealer or an experienced radio/ TV technician for help.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Increase the separation between the equipment and receiver.

Reorient or relocate the receiving antenna.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. Copyright © 2014 TP-LINK TECHNOLOGIES CO., LTD. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD.

Other brands and product names are trademarks or registered trademarks of their respective holders. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Specifications are subject to change without notice. 2.2 Installation Environment Requirements.